Hardware Manuals


Rane - TTM57 MKII  

SETUP


Connections




  • Connect your computer to USB A (or B) port at the rear panel of Rane TTM57 MKII.

  • Connect your Left deck’s RCA cables to ANALOG INPUT DECK1.
    If it’s a CD player, select CD with the switch above the input jacks.
    If it’s a turntable, select PH (Phono) with the switch above the input jacks. Secure the ground wire to a Phono Ground terminal.

  • Connect your Right deck’s RCA cables to ANALOG INPUT DECK2.
    If it’s a CD player, select CD with the switch above the input jacks.
    If it’s a turntable, select PH (Phono) with the switch above the input jacks. Secure the ground wire to a Phono Ground terminal

  • Set the SOURCE selector for DECK 1 to USB-A (or B if the USB B port is used).

  • Set the SOURCE selector for DECK 2 to USB-A (or B if the USB B port is used).

  • Connect the Rane TTM57 MKII with AC power using the provided cable and power on the unit


Drivers


Windows: Download and install the necessary ASIO drivers from https://www.rane.com/downloads-legacy#ttm57mkii

Mac OSX: Download and install the necessary CoreAudio drivers from https://www.rane.com/downloads-legacy#ttm57mkii
.
.

VirtualDJ Setup


Download and install VirtualDJ 8 from http://www.virtualdj.com/download/index.html (in case you have not done already)

Once VirtualDJ 8 is launched, a Login Window will appear. Login with your virtualdj.com account credentials.

A Pro Infinity or a Pro Subscription License is required to use the Rane TM57 MKII. Without any of the above Licenses, the controller will operate for 10 minutes each time you restart VirtualDJ.
http://www.virtualdj.com/buy/index.html




A window will appear next, to verify the proper detection.

Click on the “Use Soundcard” button and VirtualDJ will automatically create and apply the pre-defined audio configuration using the built-in audio interface of the Rane TTM57 MKII.

Click to OK.



The unit is now ready to operate with VirtualDJ.


MIDI Operation


The unit should be visible in the CONTROLLERS tab of Config and the “factory default” available/selected from the Mappings drop-down list.
The factory default Mapping offers the functions described in this Manual, however those can be adjusted to your needs via VDJ Script actions.


Find more details at
http://www.virtualdj.com/wiki/VDJ8script.html



Audio Setup


The unit has a pre-defined Audio setup and a special button in the AUDIO tab of Config to provide that. Alternative setups can be applied in the same window.



Timecode (DVS)* configuration is pre-configured (see Advanced Setup for more details).


*requires Pro Infinity or Pro Subscription License http://www.virtualdj.com/buy/index.html






For further software settings please refer to the User Guide of VirtualDJ.
http://www.virtualdj.com/manuals/virtualdj/index.html Layout