S SHIFTPress this button down to access secondary actions as described in the SHIFT ACTION column1 PLAYPlay-pause loaded trackPlay-stutter loaded track2 CUESet a temporary Cue point at current position when track is paused or preview while pressed if Cue point is assigned. Return to this Cue point when track is playingJump to the beginning of the track3 JOGTouch-sensitive jogwheel for scratching (Vinyl mode enabled), pitch-bending (Vinyl mode disabled) of fine Loop In/Out adjustments. Vinyl mode can be enabled/disabled from VirtualDJ GUI Fast-searching through loaded track4 LOOP INWhen not in loop, set current position as the beginning of a Manual Loop. When in loop, jump to the beginning of the loop. Hold for more than 2 seconds to trigger a 4 beats auto-loop.Enable/disable Loop In Adjust mode. When this mode is enabled and track is in loop (led blinks), use the jogwheel to fine-adjust the Loop In point.5 LOOP OUTWhen not in loop, set current position as the end of a Manual Loop and trigger the loop. When in loop, exits the loopEnable/disable Loop Out Adjust mode. When this mode is enabled and track is in loop (led blinks), use the jogwheel to fine-adjust the Loop In point.6 RELOOP/EXITWhen in loop, exits the loop. When not in loop, enables the last triggered loop and jumps to its beginning.Same action.7 CUE CALL <When in loop, halves the size of the loop in beats. When not in loop, loads the previous saved loop slot or saves it if emptyDelete the current Saved loop slot.8 CUE CALL >When in loop, doubles the size of the loop in beats. When not in loop, loads the next saved loop slot or saves it if emptySaves a loop of the selected beats in size to an empty Saved loop slot.9 BEAT SYNCSyncs deck with the opposite one (matches BPM and phase) or with the Master-Deck (if more than 2 decks). Press for more than 2 seconds to set a Deck as Master-Deck.Selects the next available % range for Pitch10 PITCHAdjust the tempo/pitch of the deck..11 PADSOperation depends on selected Pads mode See Pads in VirtualDJ manualOperation depends on selected Pads mode See Pads in VirtualDJ manual12 PAD MODESSelect a mode for the Pads (Hotcues, Loops, Beat-Jump and Sampler) See Pads in VirtualDJ manualSelect an alternative mode for the Pads (Cue-Loop, Pad FX, Loop Roll and Key-Cue) See Pads in VirtualDJ manual13 CROSSFADERBlends audio between the Left and Right assigned decksAdditional function: If Fader Start is enabled, start deck when reach its side, and stop if reaches the other side. See Settings14 DECK LEVELAdjust the Output volume of the Left/Right assigned deck.Additional function: If Fader Start is enabled, start deck when fader is moving from the zero position to a higher one and stop the deck when fader reaches zero/minimum position. See Settings15 CUE/PFLSends left/right deck's audio (pre-fader) signal to Headphones channel, for pre-listening .16 CFXApply the selected Color FX (by default High-Low pass Filter) to Left/Right deck. When in middle position, no Color FX is applied..17 SMART COLOR FXWhen enabled, the Gain/Trim of Left/Right Deck will be temporary set to minimum when the Color FX knobs reach at the left/right edges, offering additional mute to the applied Color FXSelect the next available VirtualDJ Color FX. see Nr.8 - Color Effects in VirtualDJ manual18 EQUALIZERAdjust the Low, Mid and High frequencies of the Left/Right assigned deck. Note The device is offering Full Stems controls. See details at EQ Modes.19 TRIMAdjust the applied Gain. When in middle position, the applied gain is following the zeroDB VDJ setting value.20 VU METERThe leds indicate the level of the Left/Right decks..21 LOADLoads the selected track from Browser to Left/Right decksLeft LOAD : sets Sideview as focused Browser window. Right LOAD : Cycles Sideview view (Automix, Sidelist, Sampler, Karaoke and Shortcuts)22 BROWSEScroll through files/folders. Push to toggle focus between Folders and Tracks Lists in BrowserPush to set focus to Folders List.. If focus is in Folders List, open/close sub-folders23 MIC LEVELAdjust the level of the Microphone input signal.24 PHONES MIXBlends audio in Headphones, between the Decks that their PFL/CUE is enabled and the Master Output (if the MASTER CUE/PFL is enabled).25 PHONES LEVELAdjust the Volume of the Headphones output.26 SMART FADEREnable/disable Smart Fader mode. When enabled (led turned on) : - The BPM of the other (non-live) Deck will be matched to the playing one. - When crossfading between the 2 Decks, both Decks will have the same BPM and at the end of the transition, both Decks will have the BPM of the other Deck. - The levels of EQ LOW will be automatically altered during the transition - An Echo Out Mix FX will be applied at the end of the transition.Same as the non-SHIFT action with the difference of the Reverb Mix FX applied instead of Echo Out (led will blink)27 MASTER LEVELAdjust the Volume of the Master output.28 MASTER CUEWhen enabled, sends audio signal from the Master Output to Headphones channel (PHONES MIX knob needs to be at a position higher to minimum.29 FX ASSIGNSelect the Deck (1=Left, 2=Right or 1&2=both Left & Right) to which the selected Effect will apply to30 FX SELECTSelect the next available Effect for the selected Deck(s)Select the previous available Effect for the selected Deck(s) 31 BEAT <>Select the previous/next size in beats for the selected Beat-aware EffectLeft button to re-analyze Track Right button to manual tap the Track's BPM32 FX LEVELAdjust the 1st Parameter of the selected Effect33 FX ONTriggers the selected Effect to the selected Deck(s) Front & Rear