Hardware Manuals


Reloop - Kut  

Setup



Connections




  • Connect your computer to the USB port at the rear panel of the Reloop KUT

  • Optionally, connect each of your deck’s RCA cables to INPUT CH1 & CH2
    If it’s a CD player, use any of the LINE Inputs
    If it’s a turntable, use the PHONE Inputs. Secure the ground wire to a Phono Ground terminal.

  • Set the SOURCE selectors at the top panel to USB 1/2 - 3/4 so that the Mixer Channels to control a VirtualDJ Deck

  • Set the MIDI switcher at the rear panel to ON

  • Connect the KUT with AC power using the provided cable and power on the unit

Note: Usage of turntables or CD players (for DVS) is not necessary. The mixer may be used as a MIDI mixer and mix internally 2 VirtualDJ decks. VirtualDJ is also offering the ability to control all the software decks with even with a single timecode unit. See Timecode (DVS).

Drivers


Firmware: (for both Windows and Mac OSX computers). At the time this manual is written, no update for the firmware is available, but you should also check the product's official page for any updates at http://www.reloop.com/reloop-kut

Windows Drivers : Install the latest Reloop ASIO drivers from http://www.reloop.com/reloop-kut

Mac OSX Drivers : No driver is required to be installed. The Mac OS will install the necessary drivers once you connect the KUT to a USB port.

See Advanced Setup for further settings.
.

VirtualDJ 8 Setup


Download and install VirtualDJ 8 from http://www.virtualdj.com/download/index.html (in case you have not done already)
Once VirtualDJ 8 is launched, a Login Window will appear. Login with your virtualdj.com account credentials.

A Pro Infinity, a PLUS* or a Pro Subscription License is required to use the Reloop KUT. Without any of the above Licenses, the mixer will operate for 10 minutes each time you restart VirtualDJ.
http://www.virtualdj.com/buy/index.html

*For DVS Support an additional Timecode Plus license is required if the Reloop KUT Plus license is purchased.


A window will appear next, to verify the proper detection.

Click on the “Use Soundcard” button and VirtualDJ will automatically create and apply the pre-defined audio configuration using the built-in audio interface of the Reloop KUT

Click to OK.

The unit is now ready to operate with VirtualDJ.


MIDI Operation


The unit should be visible in the CONTROLLERS tab of Config and the “factory default” available/selected from the Mappings drop-down list.



The factory default Mapping offers the functions described in this Manual, however those can be adjusted to your needs via VDJ Script actions.
Find more details at http://www.virtualdj.com/wiki/VDJ8script.html

AUDIO Setup


The unit has a pre-defined Audio setup and a special button in the AUDIO tab of Config to provide that. Alternative setups can be applied in the same window. See Inputs & Outputs for further details.

Timecode (DVS)* configuration is not pre-configured (see DVS Support for more details).

*requires Pro Infinity or Timecode License http://www.virtualdj.com/buy/index.html



For further software settings please refer to the User Guide of VirtualDJ 8.
http://www.virtualdj.com/manuals/virtualdj8/index.html


Layout