Hardware Manuals


Pioneer DJ - DDJ-REV7 - Layout  

EFFECTS





  • Pioneer DDJ-REV7 offers the ability to apply both hardware or software effects on each deck.
  • Only one effects mode (hardware or software) is supported at the time.
    Six Effect Slots are provided which are shared between both decks.
  • Due to firmware limitations only one (hardware or software) effect can be applied at a time at one or both decks.
  • In order to switch the unit to "Hardware" effects mode hold down Shift button and press the first Effect Slot button (Echo).
  • In order to switch the unit to "Software" effects mode hold down Shift button and press the second Effect Slot button (Spin).
  • You can select which Hardware Effects can be selected via the Effect Slot buttons from the Preferences tab in Pioneer DDJ-REV7 Setting Utility application.


  1. FX SLOTS. Select one of the six available effect slots to apply on the left/right decks.
    While the unit is in "Software" effects mode, hold down any of the six effect slot buttons and turn the "BROWSE" encoder (47) in order to select a new software effect for the given effect slot.
    Hold down Shift button and press the 1st slot button (Echo) to switch the unit to "Hardware" effects mode.
    Hold down Shift button and press the 2nd slot button (Spin) to switch the unit to "Software" effects mode.
    Hold down Shift button and press the 3rd or 4th slot button (Flanger or Reverb) to switch the Equalizer knobs to control stems instead of frequencies.
    Hold down Shift button and press one of these buttons again to switch the Equalizer knobs back to Frequency mode.
    Attention: Switching the Equalizer knobs between Frequencies and Stems requires firmware 2.01 or greater!
    Hold down Shift button and press the 5th slot button (Brake) to load Effects Bank A. This operation will also force the unit to switch to "Hardware" effects mode.
    Hold down Shift button and press the 6th slot button (Duck Down) to load Effects Bank B. This operation will also force the unit to switch to "Hardware" effects mode.
    When the unit is in "Hardware" effects mode, the selected effect slot led will blink.
    When the unit is in "Software" effects mode, the selected effect slot led will be constantly lit.

  2. FX LEVER. Apply the selected Hardware or Software Effect to the Left/Right deck.

  3. FX LEVEL. Adjust the 1st Parameter of the selected Hardware or Software Effect.

  4. FX LCD SCREEN. Provides usefull information about the selected hardware or software effect.

  5. FX PARAM L. Decrease the Beats value for the selected Hardware or Software Effect (if available)

  6. TAP. Tap this button on beat to manually calculate the BPM of a playing track in order Beat-aware Hardware Effects to be applied properly.
    Hold down Shift button and press this button to cancel manual beat Tap and return to BPM sent from VirtualDJ.

  7. FX PARAM R. Increase the Beats value for the selected Hardware or Software Effect (if available)

  8. FILTER. Apply a Color FX to the Left/Right Channel. By default Filter Color FX is selected. A different Color FX can be chosen via Pioneer DJM-REV7 Setting Utility application.
Equalizer