FRONT & REAR PANELS

Rear panel

28 USB : Set this switcher to USB position to use this device with VirtualDJ.

29 MIC IN : Connect a microphone to this socket, using a 1/4" cable. The audio signals of this input is routed directly to the Program Mix and Cue Mix.

30 MIC LEVEL : Adjust the level of the Microphone Input signal.

31 MASTER OUTPUT : Use standard RCA cables to connect this output to a speaker or amplifier system. The level of this output is controlled by the Master Level knob on the top panel.

31 MASTER INPUT : The audio signal of this input is routed to the Master Output of the device. Not used when using Computer mode and VirtualDJ

33 CUE INPUT : The audio signal of this input is routed to the Headphones Output of the device. Not used when using Computer mode and VirtualDJ

34 USB HOST : Use the provided USB type B to type A cable to connect the unit with a USB port of a computer. This USB connection sends and receives audio and control information from a connected computer.

Front panel

35 PHONES LEVEL : Adjust the volume of the Headphones output. This knob is not sending any MIDI message to the computer, so the adjustments will not affect the Headphones Volume knob on VirtualDJ GUI

36 PHONES SOCKET : Connect a pair of Headphones for pre-listening, using the 1/8" or 1/4" sockets.

For further Technical features and specifications, visit
The Next Beat
Product's Page

Hardware Integration Department 2022 - ATOMIX PRODUCTIONS

Reproduction of this manual in full or in part without written permission from Atomix Productions is prohibited.