1 CROSSFADERBlends Audio signal from Left and Right channels2 VOLUMEAdjust the Output Volume of Left/Right Channel. The series of leds next to each Volume fader indicate the pre-fader output level of Left/Right Channel3 MASTER VU METERThis series of leds indicate the output level of Left/Right stereo channels of the Master Output4 CUEUse these buttons to send the pre-fader audio signal of Left/Right channel to the Headphones channel for pre-listening5 FILTERApply a High/Low Pass Filter to Left/Right channel. When in middle position, no Filter is applied.6 EQUALIZERAdjust the 3 Equalizer bands (High/Mid and Low) for the Left/Right channel.7 GAINAdjust the pre-fader output level of the Left/Right channel.8 MASTER VOLUMEAdjust the output volume of the Master Output (connection at the rear panel)9 BOOTH VOLUMEAdjust the output volume of the Booth Output (connection at the rear panel)10 MIC LEVELAdjust the output volume of the Microphone Input (connection at the rear panel)11 CUE/PGMBlends audio signal from Master Output (when in PGM) and channels that have the CUE enabled (when in CUE) and sends to the Headphones Output (connection at the front panel)12 CUE LEVELAdjust the volume of the Headphones Output (connection at the front panel)13 TRACK SEARCHScrolls though files or folders depending on the selected Browser window. When focus is on Folders list, push to set focus to the Files/Tracks List.
While the SAMPLER button is pressed, use this encoder to scroll through the available Sampler Banks. While the SAMPLER button is pressed, push the encoder to scroll through the available Sampler Trigger modes (on/off, hold, stutter and unmute)
Push the encoder for more than 3 seconds to load the PMX10 Settings Pads page. See Advanced Setup for further details14 LOADPress to load the selected track from Browser to the Left/Right deck. Hold this button for more than 2 seconds, to switch the input of the Left/Right mixer channel to the analogue source (connections at the rear panel) or back to MIDI (for VirtualDJ Deck control)15 BACKUse this button to set focus to the Folders list of Browser. If focus is on the Folders List, use this button to open/close sub-folders16 FX ON - BOTTOMUse this button to toggle between FX Select and FX Param modes.17 FX ON -TOPUse this button to enable/disable the selected Effect on Left/Right Deck18 EFFECT 1Adjust the 1st Parameter of the selected Effect on Left/Right Deck19 EFFECT 2When the FX Select mode is enabled (default mode - FX ON BOTTOM is off) use this knob to adjust the 2nd Parameter of the selected Effect on Left/Right Deck. When the FX Param mode is enabled (FX ON BOTTOM is on) use this knob to select the Effect for the Left/Right Deck20 LOOP SIZEHalve (anti-clockwise) /Double (clockwise) the size of the Loop21 LOOP ONEnable/disable an auto-loop of the selected size in beats22 CUESSets the 8 colored Pads to Hotcues mode.23 SAMPLESSets the 8 colored Pads to Sampler mode.24 PADSIn Hotcues mode : Use the pads to assign Hotcues 1 to 8 or jump to their stored positions if not assigned. Hold CUES button down and then press a Pad to delete its stored Hotcue. In Sampler mode : Use the pads to trigger samples 1 to 8 from the selected Sampler Bank. Depending on the selected Trigger mode, you may find useful to stop a playing sample, by holding down the SAMPLES button and pressing the related pad.
