PLAY. Plays / Pauses the track. Hold SHIFT down and then press this button to "stutter-play" the track from the last set Cue Point.
CUE. When the Deck is paused, you can set a temporary Cue Point by moving the Platter to place the Audio Pointer at the desired location and then pressing the Cue Button. During playback, you can press the Cue Button to return the track to this Cue Point. (If you did not set a Cue Point, then it will return to the beginning of the track.).
If the Deck is paused, you can press and hold the Cue Button to play the track from the Temporary Cue Point. Releasing the Cue Button will return the track to the temporary Cue Point and pause it. To continue playback without returning to the Temporary Cue Point, press and hold the Cue Button, then press and hold the Play Button, and then release both buttons.
Press and hold SHIFT and then press this button to return to the beginning of the track.
PITCH BEND. Press and hold these buttons down to temporary speed up/slow down the song while pressed. When released, the track playback will return to the speed designated by the Pitch Fader. Hold SHIFT down and then use this button to select the previous/next available % range of the Pitch Fader
PITCH. Adjust the track's playback speed (tempo).
SYNC. Press this button to automatically match the corresponding Deck's tempo and phase with the opposite Deck's tempo and phase. Hold SHIFT down and then use this button to smoothly reset Tempo to its original value.
Hold the same button down for more than 2 seconds to match the Key of the Deck to the value of the opposite Deck (key Sync). Repeat the same function to reset the Deck's Key to the original value.
LOOP AUTO. Turn this encoder left/right to half/double the size of the Loop in beats. Push the encoder to enable an auto-loop of the selected size in beats or push to exit the loop.
When Track is in Loop, hold SHIFT and then turn the encoder to move the loop backwards/forward by the same amount of the loop size in beats When Track is not in Loop, hold SHIFT and then turn the encoder to move the Track backwards/forward by the same amount of the loop size in beats
JOG. Touch sensitive jogwheel. Use the jogwheel to scratch (if Vinyl mode is selected) or pitch bend. Hold SHIFT and then use the Jogwheel to fast search through the track.
VINYL. Press this button to set the Jogwheel to Vinyl (Scratch) or CD (Bend) mode. In Vinyl mode, use the outer part of the Jogwheel to bend (temporary speed up – slow down the tempo of the track). Hold SHIFT down and then press this button to turn Slip mode on/off. When enabled (led will blink), several actions such as scratching/holding Jog wheel, loops and hotcues will act temporarily and Track will resume to the position it would have been if this action was not performed.
Hold this button down for more than 2 seconds to enter Grid Edit mode (led will blink) and adjust the Beat-Grid of the loaded Track using the Jogwheel and the on-screen BPM edit buttons (see Screen). Press again to exit the Edit Grid mode
